Description

Little clicky switches are standard input buttons for electronic projects. The STEMMA Wired Tactile Push-Button Pack features five tactile push-buttons, each assembled onto a PCB with a pull-up resistor installed. The pins are normally open and momentarily close when pressed.

Each button is topped with a colorful round cap in blue, white, yellow, red, and black.

Each button board includes a JST-PH 2mm connector and a matching JST PH 3-Pin to Male Header Cable (200mm) for easy wiring.
Connect the black wire to ground, white wire to the input signal pin, and red wire to power (3V or 5V) to activate the pull-up resistor.
Compatible with Arduino, CircuitPython, Raspberry Pi, and other DIY builds.
Optionally connect using alligator clips with the STEMMA to Gator cable or directly to STEMMA 3-pin connectors using a compatible cable.

This pack is perfect for projects needing tactile inputs with simple wiring and colorful buttons.

Technical Details

Single button PCB dimensions: 28mm x 21mm x 14mm
Red wire: Power (3 to 5V DC)
White wire: Signal output, pulled high to red wire with 10K resistor, connected to ground when pressed
Black wire: Signal and power ground